出错部分:
./figure 后的结果
NOTICE: Qt will not be built with XShape support.
As a result, drag-and-drop in the Qt Designer will NOT
work. We recommend that you enable XShape support by passing
the -xshape switch to ./configure.
Qt is now configured for building. Just run 'gmake'.
Once everything is built, you must run 'gmake install'.
Qt will be installed into /usr/local/Trolltech/Qt-4.1.1
To reconfigure, run 'gmake confclean' and 'configure'.
-----------------------------------------------------------
谢谢各位了~
[ 此贴被XChinux在2006-03-26 08:50重新编辑 ]